|
|
NOTE: Revs 4.x are addendums to Rev 4, placed at the bottom of these notes. DSP10 project, and the box enclosures. The order of these notes is clearly not from beginning to end. 1 - The main pc board uses mostly surface mount parts. Stainless steel pick with a right angle bend near the tip. If so, add more flux and re-flow the connection. It is important that the iron be clean and have a shiny coating of solder. 2 - The PC board has a lot of parts on it. June and July 1999 QST on surface mount construction. Three wires are 50 Ohm coax cable. These should be installed first. AWG is probably the easiest to work with. W12 U7-4 to R60 Wire 19.68MHz to PLL IC. 4 - Do NOT have a fuse in the holder clips when you solder them! 5 - The two TO-220 voltage regulators, U10 and U102, mount under the board.
My web site - Titan Rise Experience |
|
發表於